Kenwood VZ-5000, Инструкция по эксплуатации

Страница: 14 / 80

14 English
Installation
Accessories
1. To prevent short circuits, remove the key from the
ignition and disconnect the
·
terminal of the battery.
2. Make the proper input and output cable connections for
each unit.
3. Connect the wiring harness wires in the following order:
ground, battery, ignition.
4. Connect the wiring harness connector to the unit.
5. Install the unit in your car.
6. Reconnect the
·
terminal of the battery.
7. Press the reset button. (See p. 3)
• If your car's ignition does not come with an ACC
position, connect the ignition wires to a power source
that can be turned on and off with the ignition key. If
you connect the ignition wire to a power source that
receives a constant voltage supply, as with battery
wires, the battery may die.
• If the fuse blows, first make sure that the wires have
not caused a short circuit, then replace the old fuse
with one with the same rating.
• Do not let unconnected wires or terminals touch
metal on the car or anything else conducting
electricity. To prevent short circuits do not remove
the caps from unused terminals or from the ends of
the unconnected wires.
• After the unit is installed, check whether the brake
lamps, blinkers, wipers, etc. on the car are working
properly.
• Insulate unconnected wires with vinyl tape or other
similar material.
• Thoroughly wipe away oil and other dirt from the
installation surface.
Please avoid installation on uneven surfaces.
• Mount the unit so that the mounting angle is 30° or
less.
• Do not install the receiver unit under the carpet.
Otherwise heat build-up occurs and the unit may be
damaged.
Installation Procedure
The use of any accessories except for those provided might result in damage to the unit. Make sure only to use the
accessories shipped with the unit, as shown above.
A
E
B
C
D F