TM-281A
3
3. Disconnect the fl at cable from the connector of the panel
assembly.
Flat cable
4. To remove the Display PCB, first remove the volume
knob
q
.
Then, remove the encoder knob
w
.
Remove the two screws
e
from the Display PCB using a
phillips screwdriver.
Remove the speaker holder of the key top from the
speaker.
r
Remove the Display PCB with the speaker from the panel
assembly.
t
.
.
;
@
:
=
Speaker holder
of the key top
Panel assembly
Display PCB
5. When removing the TX-RX PCB, fi rst remove the solder
of the antenna hot pin and positive terminal of the DC
cord.
Then, remove the 15 screws from the TX-RX PCB, power
module, and audio amp.
Positive terminal
of the DC cord
Antenna hot pin
Power module
TX-RX PCB
Audio amp
Note:
When you supply power to the TX-RX PCB after removing
the TX-RX PCB from the chassis, solder the positive and
ground terminals of the DC cord (recommendation: E30-
3448-25) to the +B and GND terminals of the TX-RX PCB.
TX-RX PCB
Component side
GND
+B
DISASSEMBLY FOR REPAIR