TM-281A
4
6. Pull it out behind the chassis by rotating the bush
e
of
the DC cord 90 degrees in the direction of the arrow after
the screw
q
in the negative terminal is removed, and the
positive terminal
w
is removed from the chassis.
DC cord
:
@
.
2. Precautions for Reassembly
1. Mount the key top and speaker onto the panel assembly.
Then, tighten the two screws
q
of the Display PCB.
Insert the protrusion area of the key top into the groove
area of the panel assembly using a fl at-head screwdriver.
w
Then, mount the encoder knob
e
and volume knob
r
.
:
@
.
;
:
Key top
Panel assembly
Display PCB
Speaker
2. When mounting the panel assembly, pass the fl at cable
through the hole of the chassis as shown below, then
connect the fl at cable to connector of the panel assembly.
Hole of
the chassis
Panel assembly
Panel
assembly
Chassis
Chassis
3. Fit the panel assembly into the two tabs of the chassis
top side fi rst.
Then, fit the panel assembly into the two tabs of the
chassis bottom side by turning the panel assembly.
Panel assembly
Tabs
3. How to Mount the AF PA IC (IC715)
Solder it onto the TX-RX unit (A/2) so that the AF PA IC
part number label “LA4600” is on the reverse side.
Pin 1 marker
IC715
TX-RX UNIT (X57-8130-XX) (A/2)
: TX-RX section
Component side
DISASSEMBLY FOR REPAIR