TM-281A
2
Document Copyrights
Copyright 2011 by Kenwood Corporation. All rights re-
served.
No part of this manual may be reproduced, translated,
distributed, or transmitted in any form or by any means,
electronic, mechanical, photocopying, recording, or other-
wise, for any purpose without the prior written permission
of Kenwood.
Disclaimer
While every precaution has been taken in the preparation
of this manual, Kenwood assumes no responsibility for er-
rors or omissions. Neither is any liability assumed for dam-
ages resulting from the use of the information contained
herein. Kenwood reserves the right to make changes to any
products herein at any time for improvement purposes.
1. Disassembly Procedure
1. When removing the cabinet, fi rst remove the two screws
from the right and left with a phillips screwdriver.
Then, hook your fi nger on the edge of the cabinet and pull
it out until it is over the chassis protrusion. Remove the
cabinet by prying the cabinet as shown below.
Cabinet
DISASSEMBLY FOR REPAIR
2. To remove the panel assembly, fi rst turn the transceiver
upside down.
Then, insert a fl at-head screwdriver into the holes of the
chassis and tilt it in the direction as shown by the arrow.
Panel assembly
Holes
