TK-2212/2217
10
■
Attaching the positive terminal to the chassis.
Always attach the positive terminal to the chassis, using
the following procedures, before mounting the TX-RX unit
onto the chassis.
1. Remove the holder assembly
x
from the packing
z
of
the positive terminal.
2. Mount the packing of the positive terminal into the chassis
hole
c
.
3. Mount the holder assembly into the packing of the positive
terminal
v
.
■
Mounting the chassis to the case assembly.
1. Confirm that the waterproof packing attached to the
circumference of the chassis is securely inserted in the
groove of the chassis
z
.
2. Attach the speaker to the speaker recess of the case
assembly
x
. Make sure the speaker is securely inserted.
DISASSEMBLY FOR REPAIR
Precautions for Reassembly
■
Attaching the battery release lever to the case
assembly.
1. Insert one side of the shaft into the hole at the lever fitting
section on the case assembly
z
.
Note:
The thin spring (G01-4543-04) should be positioned
above the two tabs of the lever.
2. Tilt the battery release lever slightly forward
x
, so that the
thick spring (G01-4542-04) is positioned below the case
surface.
3. With the thick spring positioned below the case surface, attach
the other side of the shaft to the case assembly by pressing
the battery release lever
c
until it snaps into place
v
.
Note:
Be careful not to tilt the battery release lever too
forward.
If the battery release lever is pushed in this state where
the two tabs come below the case surface, there is a
possibility of damaging the two tabs.
■
Assembling the battery release lever
1. Place the lever
x
onto the stopper
z
.
2. Place the thick spring
c
onto the lever.
3. Hook the right and left ends of the thin spring
v
onto the
tabs of the stopper, then place the thin spring onto the
lever
b
.
4. Slide the shaft through the hole of the stopper and lever
n
.
4
5
3
1
6
2
1
3
2
4
A thin spring
Shaft
Two tabs
A thick spring
2
1
3
4
3. Insert the upper part of the chassis into the case assembly
c
.
Note:
Take care that the speaker lead wire is not caught by
the microphone element.
4. Press the chassis
v
and the case assembly together to
attach them.
Confirm that the
waterproof packing is
securely inserted in the
groove of the chassis.
1
2