TK-2212/2217
9
DISASSEMBLY FOR REPAIR
Disassembly Procedure
■
Removing the case assembly from the chassis.
1. Remove the volume knob
z
and channel knob
x
.
2. Remove the two screws
c
.
3. Lift and remove the chassis from the case assembly
v
.
(Use a flat-blade screwdriver to easily lift the chassis.)
■
Removing the LCD ASSY from the mounting
hardware
1. Remove the sheet attached to the flat cable connector
z
.
2. Remove the FPC from the flat cable connector
x
.
Note:
Be careful not to forget to attach the sheet after the
LCD ASSY is reassembled.
3. Insert a flat-head screwdriver on the right side of the
illumination guide
c
, then lever the screwdriver to remove
the right side of the illumination guide from the mounting
hardware
v
.
4. Slide the LCD ASSY
b
to the right so that the two tabs on
the left side of the illumination guide are removed from the
mounting hardware
n
.
■
Removing the TX-RX unit from the chassis.
1. Remove the packing
m
from the SP / MIC jack of the TX-
RX unit.
2. Remove the eleven screws
,
fixing the TX-RX unit.
3. Remove the mounting hardware
.
of the SP / MIC.
4. Remove the solder of the antenna terminal with a soldering
iron
/
.
5. Remove the solder of the positive terminal with a soldering
iron
Ω
.
Note:
You can remove the TX-RX unit from the chassis without
removing the solder at the positive terminal. However,
in this case, you can not attach the packing (G53-1605-
03) that is on the positive terminal to the chassis in
assembling. So, it is advisable to remove the solder on
the positive terminal first.
6. Remove the FPC from the flat cable connector
≈
.
7. Lift and remove the TX-RX unit from the chassis
ç
.
■
Removing the battery release lever from the case
assembly.
1. Press the upper part of the lever toward the inside of the
case assembly. One side of the shaft will be removed
z
.
2. Lift and remove the battery release lever from the case
assembly
x
.
Note:
Scratch and widen the glue hole if there is difficulty in
removing the other end of the shaft.
No glue is required when you reassemble the battery
release lever.
1
3
3
4
2
2
1
3
4
Sheet
Mounting hardware
Illumination guide
Sheet
5
6
11
8
8
8
8
13
10
7
8
8
8
9
12
2
1