Kenwood ProTalk TK-3201, Руководство по обслуживанию

Страница: 3 / 39

TK-3201
3
Antenna
LED indicator
Indicates the transceiver
status. Lights red while
transmitting, green while
receiving, and flashes
red while the battery
power is low while
transmitting.
PTT (Push to
Talk) switch
Press and hold,
then speak into
the microphone
to transmit.
Call key
Press before
making a call, to
alert the other
party members.
Monitor key
Press and hold
to hear background
noise and listen
for weak signals.
Speaker/
microphone
jacks
Battery pack
(KNB-29N)
Channel selector
Rotate to change the
operating channel
from 1 ~ 16.
Power switch/
Volume control
Turn clockwise to
switch the power ON
and counterclockwise
to switch the power
OFF. Rotate to adjust
the volume.
REALIGNMENT
1. Modes
Mode Function
User mode For normal use.
PC mode Used for communication between the
radio and PC (IBM compatible).
Data programming Used to read and write frequency data
mode and other features to and from the radio.
PC test mode Used to check the radio using the PC.
This feature is included in the KPG-
90D.
User mode
PC mode
PC test mode
Data programming
mode
PC tuning mode
Tuning cable
(E30-3216-05)
RF Power meter
or SSG
Gray
Gray/Black
1.5D-XV Lead wire
1.5D-XV Shield wire +
–
+
–
}
}
SP
MIC
KPG-22
KPG-90D
IBM-PC
Fig. 1
2. How to Enter Each Mode
Mode Operation
User mode Power ON
PC mode Received commands from PC
3. Getting Acquainted
4. PC Mode
4-1. Preface
The TK-3201 transceiver is programmed using a personal
computer, a programming interface (KPG-22) and programming
software (KPG-90D).
The programming software can be used with an IBM PC
or compatible. Figure 1 shows the setup of an IBM PC for
programming.
4-2. Connection procedure
1. Connect the TK-3201 to the personal computer with the
interface cable.
2. When the POWER is switched on, user mode can be
entered immediately. When the PC sends a command,
the radio enters PC mode.
When data is transmitting from the transceiver, the red
LED lights.
When data is received by the transceiver, the green LED
lights.
Notes:
• The data stored in the personal computer must match the
model type when it is written into the EEPROM.
• Change the TK-3201 to PC mode, then attach the interface
cable.
4-3. KPG-22 description
(PC programming interface cable: Option)
The KPG-22 is required to interface the TK-3201 with the
computer. It has a circuit in its D-subconnector (25-pin) case
that converts the RS-232C logic level to the TTL level.
The KPG-22 connects the SP/MIC connector of the TK-3201
to the computer’s RS-232C serial port.
4-4. Programming software description
KPG-90D is the programming software for TK-3201
supplied on a CD-ROM. This software runs under Windows
98, ME, Windows 2000 or XP on an IBM-PC or compatible
machine.
The data can be input to or read from TK-3201 and edited
on the screen. The programmed or edited data can be printed
out. It is also possible to tune the transceiver.