NX-210(G)
4
2. How to Enter Each Mode
Mode
Operation
User mode
Power ON
Panel test mode
[ ] + Power ON
PC mode
Received commands from PC
Panel tuning mode
[Panel test mode] + [ ]
Firmware programming
mode
[ ] + Power ON
Clone mode
[ ] + Power ON
Firmware version
information
[Side1] + Power ON
3. Panel Test Mode
Setting method refer to ADJUSTMENT.
4. Panel Tuning Mode
Setting method refer to ADJUSTMENT.
5. PC Mode
5-1. Preface
The transceiver is programmed by using a personal
computer, programming interface (KPG-36A/36U), and FPU
(programming software).
The programming software can be used with a PC. Fig-
ure 1 shows the setup of a PC for programming.
MIC
PC
FPU
KPG-36A or KPG-36U
KPG-36A
Transceiver
PC
Transceiver
PC
KPG-36U
D-SUB
(9-pin)
USB
Fig. 1
5-2. Connection procedure
1. Connect the transceiver to the computer using the inter-
face cable (KPG-36A/36U), and FPU (programming soft-
ware).
Note:
• You must install the KPG-36U driver in the computer to
use the USB programming interface cable (KPG-36U).
2. When the POWER switch on, user mode can be entered
immediately. When PC sends command the transceiver
enter PC mode, and “PROGRAM” is displayed on the
LCD.
When data transmitting from transceiver, the red LED is
lights.
When data receiving to transceiver, the green LED is
lights.
Note:
The data stored in the computer must match the “Model
Name” when it is written into the fl ash memory.
5-3. KPG-36A description
(PC programming interface cable: Option)
The KPG-36A is required to interface the transceiver to
the computer. It has a circuit in its D-sub connector (KPG-
36A: 9-pin) case that converts the RS-232C logic level to the
TTL level.
The KPG-36A connects the universal connector of the
transceiver to the RS-232C serial port of the computer.
5-4. KPG-36U description
(USB programming interface cable: Option)
The KPG-36U is a cable which connects to a USB port
on a computer.
When using the KPG-36U, install the supplied CD (with
driver software) in the computer. The KPG-36U driver runs
under Windows XP, Vista ,7 or 8.
The latest version of the USB driver is available for down-
load from the following URL:
http://www.kenwood.com/usb-com/
(This URL may change without notice.)
5-5. Programming software : KPG-111D/111DN
(ver.4.40 or later) description
The FPU is the programming software for the transceiver
supplied on a CD. This software runs under Windows XP ,
Vista ,7 and 8 on a PC.
The data can be input to or read from the transceiver and
edited on the screen. The programmed or edited data can
be printed out. It is also possible to tune the transceiver.
6. Firmware Programming Mode
6-1. Preface
Flash memory is mounted on the transceiver. This al-
lows the transceiver to be upgraded when new features are
released in the future. (For details on how to obtain the fi rm-
ware, contact Customer Service.)
REALIGNMENT