Kenwood KS 100 G, Инструкция по использованию - Рекомендации по установке

Страница: 9 / 40

9
Lighting of Oven Burner
IMPORTANT: The oven door must be open during this operation.
To ignite the oven burner:
1
Fully open the oven door.
If this operation is not performed you should not proceed to light the oven.
2. Press the thermostat knob throughly to start up the electric ignition and, keeping the
knob under pressure turn it anti-clockwise (fig. 2.3) to the maximum position
240
(fig. 2.2).
Never continue this operation for more than 15 seconds. If the burner has still
not ignited, wait for about 1 minute prior to repeating the ignition.
In case of mains failure, to light the oven manually, approach a flame to the hole “ A ” of
the floor (fig. 2.4), then press and turn the thermostat knob (fig. 2.3).
3. Wait about ten seconds after lighting the burner to release the knob (priming time of
the thermocouple).
4. Check that the burner has lit; if not, turn the knob clockwise back to “
O
” (OFF) and
repeat the procedure from step 1.
5. Close the oven door slowly and adjust the thermostat knob on the desired setting.
If the flame extinguishes for any reason, the safety valve will automatically shut off the gas
supply to the burner.
To re-light the burner, first turn the oven control knob to OFF position “
O
”, wait for at least
1 minute
and then repeat the lighting procedure.
For the correct use of the gas oven see the chapters “COOKING WITH GAS OVEN” and
“COOKING WITH FAN ASSISTED GAS OVEN”.
During and after use of the oven, certain parts will become very hot.
Keep children away.
ATTENTION: In case of manual lighting, never turn the thermostat before approa-
ching a flame to the hole “A” of the floor.
A
Fig. 2.4 Fig. 2.3