KDC-W808/X689
16
(E2PROM clear)
4. DC Error Display mode is released by resetting. (What was
on the last screen will not be retained.)
●
Frequency spun switching (K/M type)
From the Power OFF condition, while pressing [1] and [5] keys
down simultaneously, press the RESET key and turn power
ON.
●
Security
• Forced Power ON mode (All models)
Even in the case where security is in effect, by simultaneously
pressing down on [EQ] and [4] keys and resetting, it is pos-
sible to turn the power on for 30 minutes only. After an elapses
of 30 minutes, restart is possible only by resetting.
• How to register the security code after replacement of the
E2PROM (F/E) (Code security models)
1. Enter the test mode. (Refer to the section on “How to Enter
the Test Mode.”)
2. By short-pressing [EQ] key, MENU can be entered.
3. Using [FM]/[AM]/[
]/[
] keys, enter the code.
[FM] key : Number up/[AM] key : Number down
[
] key : Cursor Right/[
] key : Cursor Left
4. Press [
] key for 3 seconds to display “RE-ENTER.” Then,
re-enter the code using the method in above 4.
5. Press [
] key for 3 seconds to display “APPROVED.”
6. Release the test mode. (Refer to the section on “How to
Release the Test Mode.”)
Note : The security code for this model cannot be deleted
by “all clear” command.
• Simplified method of clearing security code
1. When you are requested to enter the security code, while
pressing down on [AUTO] key, use a long-press on [
]
key for 3 seconds. (----disappears.)
2. Using the remote controller, input “KCAR.”
Press remote controller [5] key 2 times and then press
[
] key. (Input for “K.”)
Press remote controller [2] key 3 times and then press
[
] key. (Input for “C.”)
Press remote controller [2] key once and then press [
]
key. (Input for “A.”)
Press remote controller [7] key 2 times and then press
[
] key. (Input for “R.”)
3. The security is released and the unit enters the STANDBY
sourcing mode.
4. If a wrong code is input, the unit goes into the Code Re-
quest mode.
TEST MODE
