15
Basic Operation
- Setting the Cloc
k -
Setting the Clock
This may be operated only with the remote control.
In this example, the clock is set for the 24-hour (0:00) display.
Note:
The time will flash at the push of the CLOCK button when the AC power supply is
restored after a power failure or unplugging the unit.
Readjust the clock as follows.
To readjust the clock:
Perform "Setting the Clock" from the beginning.
To change the 24-hour or 12-hour display:
1
Press the CLOCK button and within 3 seconds, press the MEMO-
RY button.
2
Within 1 minute, press the PRESET ( or ) button to select 24-
hour or 12-hour display and then press the MEMORY button.
"0:00"
The 24-hour display will appear.
(0:00 - 23:59)
"AM 12:00"
The 12-hour display will appear.
(AM 12:00 - PM 11:59)
Note that this can only be set when the unit is first installed or it has been reset.
(Refer to step 3 under "If trouble occurs" on page 26.)
3
Within 1 minute, press the PRESET ( or ) button to adjust the
hour and then press the MEMORY button.
l
When the 12-hour display is selected, "AM" will change automatically to "PM".
4
Within 1 minute, press the PRESET ( or ) button to adjust the
minutes and then press the MEMORY button.
l
The hour will not advance even if minutes advance from "59" to "00".
l
The clock starts from "0" second. (Seconds are not displayed.)
To confirm the time display when the power is on:
Press the CLOCK button.
The time display will appear for about 5 seconds.
1
Clear all the programmed contents. [Perform to step 3 under "If trouble occurs" on
page 26 for details.]
2
Perform "Setting the Clock" from the beginning.
