Kenwood DRV-430, Инструкция по эксплуатации

Страница: 12 / 40

12
Adjusting the Settings to Match the Vehicle
Before using the driving support function, set
the mounting height of the device from the road
surface and adjust the horizon and hoot front
edge position settings to match the vehicle.
1.
Press the
[MENU/OK]
button.
MENU appears.
2.
Use the
[
J
]/[
K
]
buttons to select
<Driving support settings>
and then
press the
[MENU/OK]
button.
2
1
1
3.
Use the
[
J
]/[
K
]
buttons to select
<Mounting height settings>
and
then press the
[MENU/OK]
button.
2
1
1
4.
Use the
[
J
]/[
K
]
buttons to select the
mounting height from the road surface
and then press the
[MENU/OK]
button.
2
1
1
5.
Use the
[
J
]/[
K
]
buttons to select
<Detection range settings>
and then
press the
[MENU/OK]
button.
2
1
1
6.
Use the
[
J
]/[
K
]
buttons to align the guide line
with the horizon, and set the red line with the
center of the lane then press the
[MENU/OK]
button.
Adjust as shown in the figure.
1
2
2
3
7.
Use the
[
J
]/[
K
]
buttons to align
the guide line with the hoot front
edge, and then press the
[MENU/OK]
button.
Adjust as shown in the figure.
1
2
2
3
8.
Hold down the
[ ]
button to
end the procedure.
•
For the mounting height setting, set the
nearest height among the setting options.
•
In the case of a vehicle for which the bonnet
front edge cannot be seen, lower the guide line
to the lowest position at which the center of the
road surface is not hidden by the body or a part
of the vehicle and then set the setting.
•
The driving support function is set to
"OFF" by default (
Á
P.21
).
Before Using the Driving Support Function
DRV-430_B5A-0959-01_EU_EN.indd 12 2017/12/21 12:13