Kenwood DNX9980HD, Инструкция по эксплуатации

Страница: 69 / 200

English 69
Next page
3
Speaker Setup
You can select a speaker type and its size to get the
best sound effects.
1 Display the Speaker Select screen
Touch [ ]
>
[ ]
>
[Audio SETUP]
>
[Speaker Select]. (page 64 )
2 Select a speaker you wish to adjust
When the speaker type and size are set, the
speaker crossover network and equalizer curve are
set automatically.
2
1
3
4
1
Center speaker
2
Front speaker
3
Rear speaker
4
Subwoofer
[Tweeter]
You can set the tweeter when you are
selecting front speakers.
If you are using a tweeter together with the front
speakers, set the tweeter to "ON". In the "ON"
position, the Equalizer is adjusted to its best
position.
[X'over]
Displays the Speaker Crossover Setup
screen.
You can adjust the crossover setup that was set
automatically when you selected the speaker
type.
3 Select a speaker type
You can select any of the following speaker types.
"Center"
None, 2-3/4x1-9/16 inch, 2 inch, 4 inch,
5 inch, 6-1/2 inch over
"Front"
OEM, 4 inch, 5 inch, 6-1/2 inch, 6-3/4 inch,
7 inch, 4x6, 5x7, 6x8, 6x9, 7x10
"Rear"
None, OEM, 4 inch, 5 inch, 6-1/2 inch,
6-3/4 inch, 7 inch, 4x6, 5x7, 6x8, 6x9, 7x10
"Subwoofer"
None, 6 1/2 inch, 8 inch, 10 inch, 12
inch, 15 inch over
⁄
• Select "None" if you have no speakers.
• If you set the center speaker to "None" even in a short
time when you are setting the Surround Control to
"Center", the Surround Control is set to "Bypass"
automatically. See
<Surround Control> (page 68) .
• If you set the center and rear speakers to "None" when
you are setting the Surround Control to "Dolby PL II",
the Surround Control is set to "Bypass" automatically.
See
<Surround Control> (page 68) .
Crossover Network Setup
You can set a crossover frequency of speakers.
1 Select the speaker to set the crossover
2
1
3
4
1
Sets the High Pass Filter of the center speaker.
2
Sets the High Pass Filter of the front speaker.
3
Sets the High Pass Filter of the rear speaker.
4
Sets the Low Pass Filter of the subwoofer.
2 Display the Crossover setup screen
3 Set the crossover
[Phase]
Sets the phase of subwoofer output.
The phase is reversed 180 degrees when set to
"Reverse". (Only when "Subwoofer" is set to any
item other than "None" in Speaker Setup)
[HPF FREQ]
High Pass Filter adjustment. (When
front, center or rear speaker is selected on
Speaker Select screen)
[LPF FREQ]
Low Pass Filter adjustment. (When
Subwoofer is selected on Speaker Select screen)
[Slope]
Sets a crossover slope.