84
DDX630BT
Help?
Error
When the unit fails to operate correctly, the cause
of the failure appears on the display.
"Protect" :
Protective circuit has been activated because a speaker
cord has shorted or it has come in contact with the car
chassis.
➡
Wire or insulate the speaker cord as appropriate
and then push the Reset button.
"Hot Error" :
When the internal temperature of this unit rises to 60°C
or more, the protection circuit is activated and you
may not be able to operate the unit. At such times this
message will appear.
➡
Use the unit again after reducing the
temperature inside the vehicle.
"Mecha Error" :
The disc player is malfunctioning.
➡
Eject the disc and try inserting it again. Contact
the Kenwood dealer if this indicator continues
blinking or the disc cannot be ejected.
"Disc Error" :
Disc is quite dirty.
➡
Clean the disc, referring tot he section on
<Handling discs> (page 4).
Disc is upside down.
➡
Load the disc with the labeled side up.
An unplayable disc is inserted.
"Region Code Error" :
The disc you wanted to play has a region code that
cannot be played with this unit.
"Parental Level Error" :
The disc you wanted to play has a higher level than the
parental level you set.
"No Device" (USB device):
The USB device is selected as a source although no USB
device is connected.
➡
Change the source to any source other than USB.
Connect an USB device, and change the source
to USB again.
"Disconnected" (iPod):
The iPod is selected as a source although no iPod is
connected.
➡
Change the source to any source other than iPod.
Connect an iPod, and change the source to iPod
again.
"No Media File" :
The connected USB device contains no playable audio
file.
Media was played that doesn’t have data recorded that
the unit can play.
"USB Device Error!!" :
The connected USB device is rated a current capacity
higher than the allowable limit.
➡
Check the USB device.
Some trouble may have occurred to the connected
USB device.
➡
Change the source to any source other than USB.
Remove the USB device.
"Authorization Error" :
Connection to the iPod has failed.
➡
Remove the iPod and then reconnect it.
The unit does not support the iPod.
➡
Refer to <iPod/iPhone that can be connected to
this unit> (page 6).
"Update your iPod" :
The iPod's software is an older version which the unit
can not support.
➡
Confirm that the software for the iPod is the
latest version. Refer to <iPod/iPhone that can be
connected to this unit> (page 6).
"You only can connect one iPod." :
More than one iPod are connected to this unit.
➡
Connect only one iPod to the USB terminal with
iPod tag.
"No Navigation" :
This unit does not support the connected navigation
unit.
➡
The latest information on the connectable
navigation unit can be obtained from http://
www.kenwood.com/cs/ce.
No navigation unit is connected.
➡
Connect a supported navigation unit.
B64-4708-00̲00̲VW̲V̲En.indd 84
B64-4708-00̲00̲VW̲V̲En.indd 84
10.1.26 2:49:43 PM
10.1.26 2:49:43 PM