Kenwood CS-1045, Инструкция по эксплуатации

Страница: 3 / 35

FEATURES
1. Vertical axis has high sensitivity and wide bandwidth
and especially covers fully specified frequency
response at 5mV/div for all models.
C S - 1 0 6 5 ;
1 mV/div, 2mV/div : DC to 20 MHz, - 3 dB
5mV/div : DC to 60 MHz, - 3 dB
C S - 1 0 4 5 ;
1 mV/div, 2mV/div : DC to 1 5 MHz, - 3 dB
5mV/div : DC to 4 0 MHz, - 3 dB
2. Vertical sensitivity range is selectable from 1 mV/div to
5V/div with rotary switch continuously.
3. Time base permits the high sweep speed.
C S - 1 0 6 5 ; 5nsec/div ( x 10 MAG)
C S - 1 0 4 5 ; 10nsec/div ( x 10 MAG)
4. Vertical sensitivity error and sweep rate error are
± 3 % and accurate measurements are provided.
5. The 1 50 mm rectangular, domed mesh type C R T with
internal graticule provides high brightness and ac-
curate measurements, free of parallax error.
6. For convenience in making rise time measurements,
the 0 % , 1 0 % , 9 0 % and 1 0 0 % levels are marked on
the graticule scale of the C R T .
7. The built-in Auto-focus circuit keeps the waveforms in
clear focus automatically regardless of the INTENSITY
control setting.
8. Trace rotation is electrically adjustable from the front
panel.
9. By S C A L E ILLUM control, the waveform is easy
observed in darkened area and the photograph of the
waveform is easy provided a single photograph of the
waveform superimposed on the graticule scale.
10. Delay sweep modes are available in not only Con-
tinuous Delay (AFTER DELAY) and trigger Delay
(TRIG) but also both A and B zero Delay (DELAY = 0)
allowing to observe the whole extent of any com-
plicated pulse train with magnifiction as necessary.
1 1 . Single sweep permits viewing and photographing one-
time events.
12. TRIPLE mode presents a triple-trace oscilloscope; even
six traces of waveforms may be observed simultane-
ously with HORIZ MODE set at A L T .
13. The delay line permits viewing of leading edge of high-
frequency, fast risetime pulses.
14. Selectable A U T O FREE RUN function provides sweep
without trigger input signal.
15. The FRAME-LINE switch provides selection of sync
pulse for sweep triggering from small amplitude to
large amplitude without adjusting when viewing com-
posite video waveforms.
16. Vertical mode automatically provides the trigger signal
with TRIG S O U R C E and VERT MODE switches.
17. X - Y operation is easy provided by one-touche.
18. Provides with CH1 OUTPUT terminal to monitor input
signal of C H 1 .
19. DELAY TIME MULT permits the accurate time
measurements with the dial scale.