Kenwood BDR-A7, Инструкция по эксплуатации

Страница: 14 / 64

14
English
• Each time this button is pressed, the corresponding
input is selected as follows :
ANLG(Analog)
➝
COAX(Coaxial)
➝
OPTI(Optical)
■ Note :
• When the selected digital input is not connected, the
“DIGITAL” indicator flickers and the analog input is
automatically selected.
4.
Operate the selected component for playback.
• When playing back the program sources with surround
sound, refer to “ENJOYING SURROUND SOUND” on
page 17.
5.
Adjust the (overall) volume to a comfortable
listening level.
6.
To mute the sound.
• “MUTE” is displayed.
• To resume the previous sound level, press it again.
7.
To listen with the headphones.
• Then the “SPK OFF” is displayed and the sound from
the speakers is cut off.
¤ CAUTION
• A warning that excessive sound pressure from
earphones and headphones can cause hearing loss.
1.
Turn the power on.
• Each time the POWER ON/STANDBY button is pressed,
the unit is turned on to enter the operating mode (the
POWER ON/STANDBY indicator lights up blue) or off
to enter the standby mode (the POWER ON/STANDBY
indicator lights up amber).
• On the remote control, press the ON button to enter the
operating mode or press the STANDBY button to enter
the standby mode.
■ Standby mode
This means that the unit is not disconnected from the
AC mains and a small amount of current is retained to
support the operation readiness.
2.
Select the desired input source.
• Each time the INPUT SELECTOR button on the front
panel, the input source changes as follows :
FM ➝ SAT ➝ TV ➝ AUX ➝ BD/DVD
(frequency display)
• Each time the “TUNER” button on the remote control is
pressed, the FM mode changes as follows :
FM ST ➝ FM MONO
■ Note :
• During playback of BD Video or DVD Video on the BD
player, if an input source is selected and then BD/DVD is
selected within 3 minutes again, playback will be paused
on that point at which an input source is selected.
When SAT, TV, AUX is selected as an input
source
3.
Select the digital or analog input connected as
desired.
Basic Operation
■ Notes :
• Before operating this receiver with the supplied remote control, refer to “Universal Remote Controls” on page 11 for
details about operation.
• Before operating this receiver, first set this unit as desired for optimum performance, doing the setup procedures. (For
details, refer to “SYSTEM SETUP” on page 18.)
LISTENING TO A PROGRAM SOURCE
or
or
or
BDR-A7_EN_CS3.indb 14 BDR-A7_EN_CS3.indb 14 11.3.10 6:59:35 PM 11.3.10 6:59:35 PM