REV C: 06/06/18
KENTMASTER MFG. CO., INC.
1801 SOUTH MOUNTAIN AVE., MONROVIA, CALIFORNIA 91016
UNITED STATES OF AMERICA
TELEPHONE
:
(818) 359-8888
FAX:
(818) 303-5151
Page 23 of 27
NOTICE TO EMPLOYER AND PURCHASER OF TOOL
NOTICE TO SAFETY DIRECTOR
You have purchased a powerful tool that, if misused, can cause severe injury and
harm to your employees. You must instruct your employees in the safe and proper
use of this tool and to follow the safety procedures and instructions that have been
supplied by the manufacturer of this tool. Please follow the following instructions.
1.
Instruct tool operators to test the tool each day before using it to be sure it does not malfunction.
Remove and repair any tool that malfunctions.
2.
Instruct tool operators to immediately stop using a tool that malfunctions or is defective.
3.
Instruct personnel to immediately remove all tools that malfunction. Be sure to disconnect tool from
power supply.
4.
Instruct all personnel to stay clear of tool, and not to stand or walk in front of, or next to tool when in use.
5.
Point out to all personnel the dangers related to the misuse of tool and the importance of following
safety procedures and instructions.
6.
Do not make, or allow others to make, alterations or modifications to this tool.
Replace all lost or illegible labels.
7.
Follow all safety, installation and maintenance instructions provided with this tool. Establish proper
safety procedures in accordance with local and national requirements to prevent accidental energizing
of tool that can cause injuries.
8.
If this tool is sold or change in ownership takes place, you must provide the new owner all safety
instructions, notices and maintenance instructions you were originally provided. You can obtain
additional copies of the instructions from Kentmaster, free of charge upon request.
9.
Give copies of instructions to:
(A) Tool Operators
(B) Maintenance Supervisor
(C) Clean-up Supervisor
