3
1. ASSEMBLY INSTRUCTIONS
Remove your heater from the carton and assemble the base
panel as follows:
1. Use 4 x M4*10 screws, 4 x
Ф
4 washers, 4 x
Ф
4 spring
washers and 4 x M4 nuts to fix the side panel and the
base panel (see A ).
2. Use 2 x ST3.5*10 screws to fix the side panel and the
front panel, then use 2 x ST3.5*10 screws to fix the
middle panel and the base panel (see B).
Then attach the back panel to the heater properly after fitting
the LPG Cylinder inside as per the following instructions.
The cylinder should be positioned so that the opening of the
cylinder faces the access door.
Connecting your QCC1 SAFE-LOK™ Gas
Cylinder
Connecting the Regulator to the Gas
Cylinder Valve
A. Always ensure the cylinder valve is closed, by turning
clockwise fully. Fit the QCC regulator to the cylinder as
shown in Fig 1.
B. Align the Regulator Bull Nose straight to the valve (180°).
C. Turn the large black knob clockwise while engaging the
threads on the valve (Fig 2). (It is necessary to tighten the
knob completely, as the built-in safety system will only
allow gas to flow if a safe connection has been made).
It will take approximately 3-4 turns to firmly connect the
regulator to the cylinder.
D. Turn gas cylinder valve ON (anti-clockwise) as shown in
Fig 3.
E. Check for leaks on all connections using soapy water
and a brush. Bubbles will appear if there is a leak.
If you find a leak, turn valve off, undo and reattach.
If the connection is still leaking, turn the cylinder off
immediately and ventilate the space. Contact your local
LPG service agent.
Perform a leak test on all connections every time you
reconnect the cylinder, or if the heater has not been used
for a significant period.
WARNING:
For maximum safety, ensure cylinder valve is in
“CLOSED” position whenever:
a) connecting or disconnecting regulator
b) heater is not in use
c) when cylinder is stored or removed for filling
WARNING:
It is safer to contact your dealer or local service agent if
you experience any difficulty at all.
