UNCRATING:
Carefully remove protective crating so machine and parts are not marred or damaged. In
the event of damage in transit, IMMEDIATELY notify the distributor from whom the
machine was purchased, as well as the transportation company making delivery.
CLEANING:
Thoroughly clean protective coating from machine with suitab�e cleaning
solution.
WARNING
IT IS NOT RECOMME,NDED THAT GASOLINE OR ANY OTHER HIGHLY
INFLAMMABLE CLEANING AGENT BE USED.
Do not move the table, knee , saddle or ram until all way,i have been well
cleaned and lubricated. · Then, by hand, move table, saddle, and knee to
limit stop in one direction. Clean and lubricate exp'osed ways and then
move each unit to the opposite limi.t stop and similarly clean and lubricate
the exposed ways. Loosen bolts to unlock ram and move forward and
backward the full length to clean and lubricate.
POSITIONING HEA D UPRIGHT:
Loosen four locknuts (# 143, page 35) , out to detent and rotate head to vertical·
position. Proceed with alignment of head as described. on page 9 . Tighten
nuts evenly, using normal pressure. Care should be taken
.
to avoid ·excessive
tightening since this will cause distortion in the quill. Tighten all
.
nuts to
30ft.
lbs.
-
torque, then repeat to 75
ft.
lbs.
�
.
..5.
Property of Kent Industrial USA
Do Not Reproduce
