RAM POSITION
R·am can bt: movt:d by loosening two ram lock studs (#21, page 24) on turret (#11,
page 24) and moving to desired position.
CAUTION
CARE SHOULD BE TAKEN TO LOCK RA!\l
SECURELY AFTER SETTING.
NOTE
It is recommended· t.hat �n heavy milling work,
head should be kept as close to column as
possible, where maximum rigidity is obtained.
RECOMMENDATIONS:
Use
2, 3,
or
4
flute end mills, Eight flute end mill� are usually. not as
satisfactory for general milling. When using shell mills, face mills or any
other tooling, proper machining practice should be observed.
Power feed can be used for
.
d"rills up to 5/8"-diameter in mild tool steel. Overload clutch
Mi preset to l)old up to 300
lbs
down pressure on quill. -Use manual feed for drills ever
5/8"
CAUTION
THIS CLUTCH SHOULD NOT BE TAMPERED
WITH IN THE FIELD.
OPERATING INSTRUCTIONS
CAUTION
DO NOT TRY TO CHANGE SPINDLE SPEED ON 2VS VARI
DRIVE HEAD UNTIL MOTOR IS RUNNING. THIS COULD
CAUSE PARTS BREAKAGE.
Spindle feeds are adjus ted by turning speed change hand wheel (
#21 ,.
page
34) ,on the front of the belt housing. Toore are tw.o ranges shown, 75 to
550 and 550 to 3800
75-550
RPM
obtained through the back-gear drive and is referred to as
low range. To engage the bnck-gears, use the lever marked Hi-Neutral-Lo
on the right side of the head. Move this lever to'the
"LO"
position and use
low range on 'the variable spt:ed diat.
When shifting to "LO." DO NOT FORCE THE
LEVER
if the back gears do not
mesh. Hold the lever so that the gears are clear of one another, rotate the
spindle nose by hand until the gears line up, then put the unit in "LO"
( back gear) .
- 1 9-
Property of Kent Industrial USA
Do Not Reproduce
