Kent Euroclean 56010923, Руководство оператора

Страница: 10 / 17

9 - FORM NO. 56041490 / DuraVac
™
152
CLEANING THE VACUUM INLET FILTER
The vacuum inlet filter catches any dirt spilled from the bag, before it can
enter the vacuum motor. The filter is located just below the bag. Clean
the filter every third time that the bag is changed (more often in very dusty
applications). To clean the Vacuum Inlet Filter...
1 Push the Bag Housing Latch (16) in and remove the back cover.
2 Slide the Filter Holder out of the bottom of the Bag Housing.
3 Remove the filter and wash it in warm water. Let the filter dry
completely before putting it back into the machine.
IMPORTANT !
Never operate the machine without the Vacuum Inlet Filter in
place.
D-CHANGING THE ELECTROSTAT EXHAUST FILTER
The electrostat exhaust filter catches any dirt that may escape from the
dust bag, vacuum inlet filter, or lower motor filter. The electrostat exhaust
filter is located just below the carrying handle. Replace the filter every
fifth time that the dust bag is changed (more often in very dusty
applications).
To replace the Electrostat Exhaust Filter...
1 Push the Filter Cover Latch (19) in and remove the Electrostat
Exhaust Filter Cover (18).
2 Remove the Filter from the filter holder and insert a new filter in its
place.
3 Snap the Filter Cover back into place.
IMPORTANT !
Never operate the machine without the Electrostat Exhaust Filter
in place.
CHANGING THE BRUSH
1 Remove the bottom cover from the brush housing.
2 Grasp the center of the brush and pull it out of the base.
3 Pull the metal brush support off the brush.
4 Hold the pulley and turn the brush 1/4 turn (clockwise). Pull the
brush off the shaft.
5 Follow the instructions in reverse order to install the new brush.
REPLACING THE BELT
WARNING !
To reduce the risk of electric shock, unplug before servicing.
1 Remove the bottom cover from the brush housing.
2 Grasp the center of the brush and pull it out of the base.
3 Remove the top cover from the brush housing.
4 Remove the old belt from the motor pulley.
5 Install the new belt on the motor pulley.
6 Install the brush with the new belt around the brush pulley.
7 Put the bottom and top covers back on the brush housing.
TECHNICAL SPECIFICATIONS (as installed and tested on the unit)
Model DuraVac™ 152
Voltage V/Hz 120/60
Rated Power W 870
Protection Class (electrical)
Sound Pressure Level
dB(A)/20µPa 69
Total Weight lbs / kg 19 / 8.6
Vibrations at the Hand Controls m/s 2 <2.5m/s 2