Kenmore 796.405190, Руководство по обслуживанию

Страница: 17 / 59

16
No. Process Explanation
A. Intermittent
spin • To reach the correct set speed, the motor rotates clockwise and
counterclockwise directions after spin process starts.
• If the water level frequency is lower than 23.0 kHz, a washer senses
suds and starts suds removal process.
B. Rinse
spin • In this process, the remaining water during washing process is
extracted and the selected speed is kept.
• Removing suds process is in active mode at this cycle.
C. Remaining
spin • After spin finishes, the drum rotates by remaining spin power until it stops.
Motor power is off.
• This process is overlapped with next process.
D. Rinse water
supply • Water supply for rinse process
E. Rinse • Rinsing process.
F. Last
drainage • After spin finishes and power is not supplied to motor, the drum
rotates by remaining spin power
• If rinse hold is selected, the drainage is not proceeded after rinse
finishes.
G. Disentangling • The same as item 9.
H.
Intermittent spin • The same as item A.
I. Main spin1 • The same as item B.
J. Main spin2 • At the end of a main spin, the spin speed will reach the selected rpm.
K. Remaining spin • The same with item C.
L. Disentangling • After spin finishes, disentangling starts to remove unbalanced
laundry.
M. End • After 'end' signal is displayed, it stays for 8 seconds and power is
automatically turned off. (Auto type door switch)
• After door switch is off, end signal is displayed in the case of
manual type and it takes around 2 minute to turn off door switch.