![background image](http://html.mh-extra.com/html/kenmore/253-7031-series/253-7031-series_use-and-care-manual_185473008.webp)
8
Installation (Continued)
Leveling Freezer Drawer (if necessary)
To level the freezer drawer:
1. Check gasket seal around top, bottom, and sides of
freezer drawer.
2. If gasket is not sealed, open drawer and slightly loosen
four drawer screws (two on each side) to allow drawer to
rotate.
To level the cabinet using the front rollers:
1. Slightly open freezer drawer. Lift the toe grille and gently
pull forward (see illustration).
2. You can raise or lower each door. Use a ⅜ inch socket
wrench to turn the adjustment screws (one per side).
3. Close drawer and recheck the seal on the gasket (A).
Open the drawer grabbing by the sides in the center (B).
Be careful not to rotate the drawer.
4. Tighten four drawer screws.
5. Recheck gasket seal.
Level Refrigerator & Adjust Doors (if necessary)
Guidelines for final positioning of your refrigerator:
• All four corners of the cabinet must rest firmly on the floor.
• The sides should tilt ¼ inch (6 mm) from front to back (to
ensure that doors close and seal properly).
• Doors should align with each other and be level.
Most of these conditions can be met by raising or lowering the
adjustable front rollers.
Pull Drawer Out
From Both Sides
Grab Drawer
At Center
Then
Push Against
Freezer Drawer
A
B
Raise
Lower
Anti-tip
Leg
Door
Door
To raise
: turn adjustment screw clockwise.
To lower
: turn adjustment screw counterclockwise.
3. Ensure both doors are bind-free with their seals touching
the cabinet on all four sides and that cabinet is stable.
4. After unit is leveled, lower anti-tip leg until it contacts the
floor.
5. Install the toe grille by fitting into place.
Remove Hex
Head Drawer
Screw
Remove Hex
Head Drawer
Screw
Do Not Remove
Other Screws
Do Not Remove
Other Screws
Remove Hex
Head Drawer
Screw
Remove Hex
Head Drawer
Screw