ELECTRICAL REQUIREMENTS
INSTALLING YOUR DEHUMIDIFIER
4
OBSERVE ALL LOCAL CODES AND
ORDINANCES.
DO NOT, UNDER ANY CIRCUMSTANCES,
REMOVE THE POWER SUPPLY CORD
GROUND PRONG.
ELECTRICAL GROUND IS REQUIRED ON
THIS APPLIANCE.
A 115-VOLT 60Hz, AC ONLY, 15A
FUSED AND PROPERLY GROUNDED
ELECTRICAL SUPPLY IS REQUIRED.
A time delay fuse or time delay circuit
breaker is recommended. Use a dedicated
circuit serving only this appliance.
DO NOT USE AN EXTENSION CORD.
• Install the dehumidifier on a level floor
strong enough to support the unit with a
full bucket of water.
• For best performance, allow at least 12-
18 inches of air space on all sides of the
unit for good air circulation.
• Keep all outside doors, windows and
other openings closed when operating the
dehumidifier. Humid outdoor air will add to
the unit’s workload.
• For maximum efficiency, install your
dehumidifier in an area where the
temperature will not fall below 65°F.
RECOMMENDED GROUNDING METHOD
For your personal safety, this appliance
must be grounded. This appliance has a
power supply cord with a 3-prong grounded
plug. To minimize possible shock hazard,
the cord must be plugged into a matching
grounded electrical outlet that complies with
the latest edition of the National Electrical
Code and all local codes and ordinances.
If a grounded 3-prong electrical outlet is not
available, it is the personal responsibility
and obligation of the customer to have one
installed by a qualified electrician.
ELECTRICAL SHOCK HAzARD
Plug into a grounded 3-prong outlet.
• Do not remove ground prong.
• Do not use a two-prong adapter.
• Do not use an extension cord.
Failure to follow these instructions can result
in death, fire or electrical shock.
WARNING
Power supply cord
3-prong grounded plug
Grounded 3-prong
electrical outlet
• At temperatures below 65°F, the evapor-
ator coils may become covered with frost,
reducing the dehumidifier’s performance.
• Leave the dehumidifier in an upright
position for 30 minutes before turning on.
DEFROST OPERATION
The dehumidifier has a built-in defrost
control that senses frost buildup on the
evaporator coils.
During defrosting, the compressor will
automatically turn off; the fan will continue
running to defrost the coils.
