Kenmore 153.321160 страница 16 Скачать руководство пользователя

Страница: 16 / 28

Before Using

1. Make sure the water heater has been properly

installed. See “Installing Your Water Heater” section.

2. Make sure the air filter is correctly seated, as it may shift

during shipping or installation. See “Repair Parts Illustration”
section.

3. Completely fill the tank with water (See “Water Piping”

section).

4. After the water heater tank is completely filled with water,

connect electrical power to the water heater.

5. Read the “Water Temperature Regulation” section of this

manual. If you do not fully understand these instruction,
contact a quali

ed person.

6. Press the power button (See Figure 16) to turn the water heater

on and allow it to run a system diagnostic check. This typically
takes eight minutes. Once complete, proceed to the next step.

NOTE:

If the system diagnostic check yields any codes,

reference the Diagnostic Code section in this manual.

7. Adjust the thermostat to the desired temperature

setting as described under “Adjusting the User Interface
Module/Operational Modes” section.

IMPORTANT:

Do not attempt to operate this water heater if the

unit has been submerged, subjected to

ooding, or surrounding

insulation has been exposed to water in any way.

Do not attempt to repair a unit subjected to

ood conditions.

Water heaters subjected to

ood conditions or any time the unit

has been submerged in water require replacement of the entire
water heater.

Temperature Regulation

HOTTER WATER CAN SCALD: Water heaters are intended
to produce hot water. Water heated to a temperature which
will satisfy clothes washing, dish washing, and other sanitizing
needs can scald and permanently injure you upon contact. Some
people are more likely to be permanently injured by hot water
than others. These include the elderly, children, the in

rm, or

physically/mentally handicapped. If anyone using hot water in
your home

ts into one of these groups or if there is a local code

or state law requiring a certain temperature water at the hot water
tap, then you must take special precautions. In addition to using
the lowest possible temperature setting that satis

es your hot

water needs, some type of tempering device, such as a mixing
valve, should be used at the hot water taps used by these people
or at the water heater. Mixing valves are available at plumbing
supply or hardware stores. Follow manufacturers instructions for
installation of the valves, Before changing the factory setting of
the thermostat see Temperature Settings table below.
Never allow small children to use a hot water tap, or to draw
their own bath water. Never leave a child or handicapped person
unattended in a bathtub or shower.
The water heater is adjusted to a temperature setting of no
higher than 120°F when it is shipped from the factory. Water
temperature can be regulated by adjusting the User Interface
Module to the preferred setting as shown in “Adjusting the
User Interface Module/Operational Mode” The preferred
starting point is 120°F. There is a hot water scald potential if
the temperature set point is set too high.

IMPORTANT:

Adjusting the set point above 120°F on the User

Interface Module will increase the risk of scald injury in the
times shown below.

Water

Temperature

°F

Time for 1st

Degree Burn

(Less Severe Burns)

Time for Permanent Burns

2nd & 3rd Degree

(Most Severe Burns)