www. kenall.com P: 800-4-Kenall F: 847-360-1781 1020 Lakeside Drive Gurnee, Illinois 60031
6
INSTALLATION INSTRUCTIONS
CSMRI_F-3732_050813
NOTE: HANDLING THE GRAPHIC PANEL
SHOULD BE DONE IN A CLEAN, DUST-FREE
ENVIRONMENT TO PREVENT
TRAPPED PARTICLES BETWEEN THE CLEAR
OUTER LENS AND THE GRAPHIC PANEL.
HANDLE WITH EXTREME CARE BY
USING PROTECTIVE MEASURES. SOLVENTS
AND OILS FROM THE SKIN MAY
PERMANENTLY DAMAGE THE IMAGE.
• Remove hex nuts from all four (4) retaining
brackets on the back side of the door. See
Figure 4.
• Remove retaining brackets and existing
graphic panel.
• Check for dust and contaminants on
the clear lens surface. Clean if necessary
following procedure in Section V.
• Install new graphic panel.
• Reinstall retaining brackets. Make sure
internal hinge/spring clips are installed on
opposite sides of each other and, when
installed into the lightbox, will put the
image in the correct orientation.
• Fasten all hex nuts to retainer brackets.
Torque all fasteners equally to 12 lb-in.
• Reinstall door and fasten lens screws
V. Cleaning the Lens and Graphic Panel
Use the following procedure to properly clean
the graphic panel and clear, acrylic outer lens.
This should be done in a clean, dust-free
environment to avoid additional
contamination. The back side of the graphic
panel is a sensitive photographic film. Handle
withextreme care. Avoid contact with
solvents and oils from the skin as they may
permanently damage the image.
• Remove graphic panel from door.
• Gently wipe down image with a clean,
damp micro-fiber cloth. Hard wiping and
abrasive cloths will scratch the film and
clear lens.
• For heavier smudges and residue, use a
diluted mild dish soap solution. Afterward,
rinse-off solution with a clean, damp
microfiber cloth.
• Dry panels with a clean, dry
micro-fiber cloth.