PROMIG 200ML/0509 – 5
© KEMPPI OY
G
C
H
E
I
B
F
D
A
J
K
L
M
E
D C
A
F
B
Inside
A
Selection of air/liquid cooling
B
Wire reel locking
C Wire
inch
D Gas
test
E Tightening
screw
F Feed
roll
2.5. Lifting the equipment
For transferring the equipment or a part of it, use the machine handles. Machines can
be lifted with ropes. Fasten the ropes carefully round the machine. Note! Check that the
machine can not move vertically between the ropes.
2.6. Filler wire materials and equipment
2.6.1. Filler wires and wire feed
Choose contact tube, wire conduit and feed roll according to welding wire. Filler wires
and the corresponding wire feed equipment are presented in the following scheme. The
factory assembly includes feed rolls with plain groove and with orange wire guide tubes
for welding
fi
ller wires of 0.9-1.2 mm (0.035”, 0.045” and 0.052”).
Back side
Connections:
J
Control cable to power source
K
Shielding gas hose (snap connector)
L
Welding current cable
M
Connection for MMA
Front machine
A
Welding voltage (MIG)
B
Wire feed speed (MIG) / Wel-
ding current (MMA)
C Main
switch
D Control
mode
E
Flowmeter / regulator for shiel-
ding gas
F Function
panel
Connections:
G
Control cable of remote control
H
Control cable connector for sub-
feeder / motorized gun
I
Welding gun cable
2.4.2. Main parts and connections
