PROMIG 200ML/0509 – 12
© KEMPPI OY
Shape of arc in SYNERGIC PULSED MIG:
In SYNERGIC PULSMIG the control for welding dynamics has an in
fl
uence on shape
of pulsed MIG arc.
-9...-1 Wider pulsed MIG arc. Object: e.g. welding of square butt preparation
0
Recommendable basic setting
1...9
More narrow and better directed arc. Object: e.g.
fi
llet weld seams of thin basic
materials
Control of MMA dynamics
With control of MMA dynamics you can in
fl
uence on arc in different situations.
When you make the arc harder, blow and at the same time spatter is increased.
-9...-1 Softer arc. Object: Minimizing spatter in welding at upper end of recommen
ded currents for electrode.
0
Factory setup. Normal setting for all electrode types.
1...9
Harder arc. Object: e.g. cellulose covered electrodes (9) and thin stainless
electrodes in welding at lower end of recommended currents for electrode.
Shielding gas
fl
ow regulation
Shielding gas
fl
ow can be regulated with a
fl
ow regulator 5....25 l/min. The display is
calibrated for Ar CO2 mixed gas (75% Ar, 25% CO2). With other gases the meter error
tolerance remains within ±10% compared with real
fl
ow. This is reached only when the
angle of de
fl
ection is smaller than 15° in regard to vertical. Regulate the meter always
having the unit is in vertical position. Gas
fl
ow is shown in the centre of swimmer.
3.4. Selecting and adjusting welding settings
See 3.3. Operation functions
3.4.1. MIG/MAG -welding
1.
Select welding process MIG 2T or 4T with selection switch.
2.
Select welding settings control mode local control, gun control or remote cont-
rol with selection switch.
3.
Select xx from special functions.
4.
Select wire feed speed m/min and welding voltage with potentiometres.
5.
If necessary, set welding dynamics from the potentiometer.
6.
Start welding and adjust wire feed speed and voltage if needed.
3.4.2. Synergic MIG/MAG -welding (1-MIG)
1.
Select welding process MIG 2T or 4T with selection switch.
2.
Select synergic welding by switching on 1-MIG.
3.
Select material and welding wire diameter with selection switches.
4.
Select welding settings control mode local control, gun control or remote cont-
rol with selection switch.
5.
Set the welding power and arc lenght with the corresponding potentiometers.
Values are shown in displays.
6.
If necessary, set welding dynamics from the potentiometer.
7.
Start welding and adjust welding power and arc length if needed.
3.4.3. Synergic pulsed MIG -welding
1.
Select welding process MIG 2T or 4T with selection switch.
2.
Select pulsed MIG welding with the selection switch.
3.
Select material and welding wire diameter with selection switches.
