Kemppi A5 MIG Rail System 2500, Руководство по эксплуатации

Страница: 5 / 18

5
A5 MIG Rail System © Kemppi Oy 2021 R01
OPERA
TING M
ANU
AL
2. INSTALLATION
2.1 Connecting to a FastMig welding
machine
To connect the carriage system to the FastMig welding
equipment:
1. Connect welding cable to welding gun connector.
2. Connect control cable to remote control
connection at the wire feeder.
3. Connect control cable to 7-pin connection at the
carriage unit.
4. Connect remote control unit to 7-pin connector on
the carriage front panel.
With Kemppi mechanization welding gun, the control
cable is integrated into the gun cable. The trigger mode
must be set to 2T. With other welding guns, you need to
use a separate control cable. See the ordering codes at the
end of this document.
2.2 Connecting to a non-FastMig
welding machine
You need a transformer (1-phase, 230 VAC) to power the
carriage. In this setup, the start button and the adjustment
of welding voltage and wire feed speed are not accessible
through the remote control device.
Do the following to connect:
1. Connect welding gun to the wire feeder.
2. Attach welding gun to the carriage gun holder.
3. Connect transformer to the carriage.
4. Start welding by pressing the gun trigger.
When using a manual welding gun, start and stop
the arc with the gun trigger and start the carriage motion
with the remote control as usual. The trigger mode must
be set to 4T. See FastMig operation manual for further
instructions.
When using a Supersnake:
1. Use the mechanization model of Supersnake.
2. Connect as usual to the wire feeder, and connect
the carriage with the welding gun to the
Supersnake. This model includes a bus coupler with
which to connect.