Kemppi A5 MIG Rail System 2500, Руководство по эксплуатации

Страница: 12 / 18

12
A5 MIG Rail System © Kemppi Oy 2021 R01
OPERA
TING M
ANU
AL
Delay Car
A CH off
Delay Car: 600 ms
Set the start delay (the time that the carriage stands still
after welding has started):
1. Use + and – buttons to change the time.
2. Range: 100–3000 milliseconds
3. Press MENU to continue
Value CH2-CH5
A CH on
Value CH2: 4
Fine adjust the signal level of the memory channels at
the welding carriage for channels 2 to 5.
• Use + and – buttons to change the value.
You need to change these settings only if there is a
conflict between the memory channels set by the wire
feeder and the welding carriage.
Adj0 WF
A CH on
A dj. 0 WF: 5
With this parameter you can fine-tune the signal zero
level for setting the wire feed speed value.
• Use + and – buttons to change the value.
In normal use, you never need to change the value
of this parameter.
Adj0 V
With this parameter you can fine-tune the signal zero
level for setting the voltage value.
• Use + and – buttons to change the value.
In normal use, you never need to change the value
of this parameter.