Kemper ProfiMaster KE 60650100, Руководство пользователя, Страница: 17 / 45

KEMPER ProfiMaster Manual EN
Art. No.: 150 2121 - 13 - Rev.: 1
Subject to technical modifications and errors.
Issued: 10/2013
5 Assembly
WARNING
Serious injury possible when mounting the extraction arm due to
pretension of the coil springs used. Mishandling the support
frame can result in it moving unexpectedly and could cause
severe facial injuries or crushing of fingers!
NOTE
When installing the ProfiMaster independently, the ProfiMaster
operator must only appoint persons who are familiar with the task.
Two employees are needed for the installation of the unit.
5.1 Unpacking and assembly of the wheels
●
Remove the small boxes from the large packaging (wrappers) and set them to
one side.
●
Now lift the big outer packing up and off.
●
The ProfiMaster is secured by straps in a cardboard bottom on the pallet. Cut the
corners of the cardboard bottom with a knife, so that you can fold the sides down.
Also carefully cut the straps.
●
Located in one of the smaller boxes are two large rear wheels with a pre-mounted
axle and two smaller castors with brakes, also with pre-assembled axle.
●
At the back of the unit is a handlebar. Pull this handlebar and tilt the unit in this
way slightly back so that the unit lifts about 150mm off the ground at the front.
●
While you are holding the unit in this position, a second employee twists the
castors with their axles from below in the existing screw sockets in the front
corners in the bottom plate of the unit.
●
Now, lower the front of the unit slowly and lift it by the handlebar a little. The
second employee can now screw in the large rear wheels with their pre-installed
axle into the screw sockets located at the side.
●
Now gently pull the ProfiMaster backwards off the palette.
●
Open the access door and check the filter cartridges to make sure they are
undamaged and in the correct arrangement.