Kemper AA800INR, Руководство пользователя и обслуживания

Страница: 31 / 45

Page | 30
MAINTENANCE
Ordinary maintenance is not included in the warranty.
Proper use of the appliance and proper and regular maintenance are essential to ensure better performance and longer
service life.
Periodic maintenance
At least once a year before the start of the season, it is recommended that:
•
Gas pipe replacement if damaged
•
Replacing the worn parts of the heater
•
External heater cleaning with wet soft cloth, not inflammable or corrosive solvents
Depending on the quality of the type of gas used, it is possible that the glass tubular obscures due to the
components added to the propane gas mixture and generally to the dirt; for the internal cleaning of the glass
tube you can use a soft cloth, restoring the initial transparency.
Glass tube replacement
If you need to replace the glass tube (important blackening after a few years, or accidental breakage) proceed as
follows:
- wait until the heater is cold, in all its parts
- Remove hat by acting on the 3 bolted links (cross head) M5 placed on the top of the hat
- remove the broken glass tube -
PAY ATTENTION
- reassemble hat
Glass tube cleaning
If glass cleaning is required, proceed as follows:
•
Wait until the heater is cold, in all its parts
•
Remove hat by acting on the 3 bolted links (cross head) M5 placed on the top of the hat
•
remove the broken glass tube - PAY ATTENTION
•
Use a wet cloth to clean the inside of the glass by gently passing it from one end to the other until the glass
returns clean
•
Put the glass back in its position and reassemble the hat
MANDATORY; the heater must be carried / moved only when it is cold and in the absence of gas tank
(safety and protection components).
Anomalies, possible causes and remedies
Anomalies Possible causes Remedies
A Pilot ignite, main burner A1 Gas tap anomaly A1 Replace the gas tap
does not ignite
B Continuous spark, B1 Lack of gas B1 Check opening of the gas tap, on the
the pilot does not ignite gas tank, check gas adaptor
B2 Pilot cluster obstruction B2 Clean the pilot cluster (qualified personnel)
B3 Thermocouple anomaly B3 Replace thermocouple
B4 Anti tilt sensor blocked B4 Replace anti tilt sensor
C The pilot ignites and then C1 Thermocouple anomaly C1 Replace thermocouple
shuts off as soon as
the tap is released
D There is no spark at the D1 Damaged discharge electrode D1 Electrode replacement
pilot ignition D2 Disconnected discharge cable D2 Reconnect with its faston
E Lack of flame E1 Bad LPG gasification E1 Replace the gas tank
E2 Thermocouple interrupted E2 Replace the thermocouple
E3 Obstructed gas circuit E3 Clean the gas circuit
E4 Leaks in the gas circuit E4 Fix any leak
E5 Gas regulator to be replaced E5 Replace the gas regulator
F Glass tube blackening F1 Low quality gas F1 Use better quality gas
F2 Bad draft F2 Check for wind presence
F3 Dirty burner F3 Clean the burner with low pressure air
before carrying out any maintenance operations, make sure that the gas tap has been closed and that
the appliance is cold
; For all routine and / or extraordinary maintenance work, consult only
professionally qualified personnel, or rather the KEMPER Technical Support Center
EN