Kemper 460plus, Руководство оператора

Страница: 77 / 112

Lubrication and Periodic Service
KM00321,0000BAD -19-10MAY21-1/1
OUKM001,0000014 -19-15FEB05-1/1
Releasing Pneumatic Pressure from the
StalkBuster™ Units
CAUTION: Before carrying out adjustment, repair
and maintenance work, release the pneumatic
pressure from the StalkBuster™ units.
1. Turn the knob (A) at the control valve (B) clockwise to
release the pneumatic pressure.
NOTE: The control valve (B) is located on the
right-hand side of the header (viewed in
direction of travel).
2. Pull the cargo box power lift (C) in the direction of
the arrow. Secure the cargo box power lift (C) with
a padlock to prevent accidental activation of the
pneumatic pressure.
3. Disconnect the pneumatic hose (C) from the forage
harvester.
A—Knob
B—Control Valve C—Lever
D—Pneumatic Hose
KM410699
—UN—06MA
Y20
KM508703
—UN—10MA
Y21
At the Start of Every Harvesting Season
Before putting the harvester into operation, carry out a
general check of the friction clutches in the main drive,
and do a check on the gatherer drums. In the "Service"
section, see "Relieving Pressure at the Slip Clutches on
the Main Drive".
Run the rotary harvesting unit for a few minutes. Then
check all the bearings. If overheating or excessive play
is found, replace the relevant bearings before operating
the rotary harvesting unit.
60-4 061721
PN=77