KEMKRAFT
ENGINEERING, INC.
MODEL KEI-200A SPC DIGITAL INCLINOMETER
96-014.doc
Page 6 of 8
47650 CLIPPER DR. PLYMOUTH TWP., MI. 48170 (734) 414-6500
Barcode SCANNER Option
The KEI-200A was developed to allow the user to scan a Vehicle Identification Number (VIN)
of the vehicle that is being audited. This allows the VIN to be stored along with the drive audit
average for the vehicle. This information can be uploaded to a P.C. for S.P.C.
OPERATION
The KEI-200A is designed to have the scanner plugged directly into the 9 pin serial port.
1). This port provides power and communication to barcode scanner.
2). This port is also used to upload the stored audit data.
Plug the bar-code scanner into the serial port.
Toggle the power switch, located on KEI-200A the front panel, to turn the unit on. The
barcode scanner will beep to confirm power up. The unit should display the following:
KEI200-A 0=SETUP
1=RUN 2=DOWNLOAD
Press 1
- To enter Run mode. The unit should display as follows:
Scan the Barcode
[SMPL] when done
Press SMPL
-
To enter the VIN number in manually.
Barcode Scanner Gun Option:
Direct the scanner at the desired build sheet VIN and press the trigger. The scanner will emit
a visible RED horizontal beam. This beam scans the bar-code. When the scanner has a
good scan, a green LED on the unit will blink and the unit will beep. The KEI-200A should
display the following:
Barcode Scanner Wand Option:
Place the scanner tip to the left of the desired build sheet VIN and press the trigger. Draw a
line with the tip of the scanner across the VIN barcode. When the scanner has a good scan, a
green LED on the unit will blink and the unit will beep.
The KEI-200A should display the following:
VIN
XXXXXXXXXX
Save? 1=Yes 0=N0
Press 0:
To discard the scanned VIN number. The saved Drive Audit Data will not have a VIN
number.
Press 1:
To apply the scanned VIN number to the Drive Audit data.
The KEI-200A is now ready for a Drive Audit. (Refer to Operating Procedure.)
