8
Epos 300 User Manual www.kelvinlight.com
protected.
5.2 Use of Bowens Mount Reflector
Start installing the Bowens Mount reflector by inserting the reflector into the Bowens mount and rotate it counter-
clockwise. Click the release button and rotate the reflector clockwise to release.
5.3 Attaching the Tilt Lock Handle
The tilt lock handle can be attached to either side of the Epos 300. To attach the handle, follow these steps:
1. Place the Epos 300 and yoke face down on a flat surface.
2. Use the correct hex key to remove one of the tilt control screws and replace it with the tilt lock handle. Screw
in the handle so the threads are engaged, but don’t tighten it.
3. Use the hex key to tighten the control screw on the other side of the yoke. Tighten it enough until there is
some resistance while tilting the Epos 300 in the yoke.
4. Tighten the handle until the yoke is locked and secure.
Note: If the yoke seems too loose when the tilt lock handle is disengaged, use the hex key to slightly tighten the
control screw opposite the handle.
