Kellfri 35-FDM160, Руководство пользователя

Страница: 3 / 56

3
Table of Contents >>
INTRODUCTION
Thank you for choosing a product from Kellfri AB. Compliance with the safety instructions, operating
manual and sound common sense will guarantee many years of enjoyment using the product.
Kellfri's equipment and products are aimed at self-employed farmers, horse enthusiasts and other
country-dwellers who have stringent performance demands.
PRODUCT INFORMATION
The FDM160 rotary disc mower is suitable for you if you are looking for a slightly smaller rotary
disc mower to use on small to medium-sized pastures. The rotary disc mower has a working width
of 1.6 m and is adapted for tractors from 35 hp.
The mower is equipped with four oval rotary discs that cut the grass effectively, with better cutting
performance that gives good growth. There are two raised rotary discs with guide blades in each
outer edge, which raise the throughflow speed and ensure that the crop flows freely without
interruption. Individual skids under each disc protect the cutterbar, which lies well balanced and
very lightly against the ground.
The rotary disc mower is fitted with a protective cover over the whole cutterbar, protecting both the
tractor and the surroundings from stone chippings and grass spray. The protective frame around
the cutterbar is constructed of a single frame which gives stable support to the entire protective
frame and protective cover.
The protective frame can also be folded open during maintenance.
The cutterbar is fitted with gliding plates at both ends.
The machine is equipped with a stone ejector as collision protection, which ejects backwards at
an angle in order to reduce stresses in a collision.
Adjustable relief springs relieve the pressure of the rotor cutterbar against the ground to minimise
damage to the ground.
The rotary disc mower has a hydraulic raising function with a manual lock for a secure transport
mode. The transport width is no wider than the tractor.
Geometrical and powerful energy transmission from PTO to cutterbar by means of ventilated belt
drive and bevel gear.
TECHNICAL DATA 35-FDM160
Machine dimensions 3560 x 1200 x 1320 mm
Working width 1600 mm
Operating height, min-max 60-100 mm
Rotary discs (oval) 4 pcs
Blades 8 pcs
Working angle +90 to -35 degrees
PTO shaft Standard
Power requirement, hp 35-50
Weight 495 kg
Three-point linkage Cat.1 and Cat.2
PTO - rpm 540
Cutterbar - transmission oil 80W-140 1.4 lit
(NB Exact quantity is important.)
Gearbox - transmission oil 80W-90 0.4 lit (NB Exact quantity is important.)