and run-on timers previously described. To access the advanced functions
press
(^)
followed by
(P)
.
If you do not require advanced functions press (P). You are then
presented with a screen asking you to accept the current settings and
exit the menu and run the pump.
Press
(P)
to select this option or press the
(v)
button to move to the next
option.
SINGLE BATCH
Means batch runs that repeat with an automatic delay between each batch.
Selecting repeat batch enables delayed restarting, a function that follows
batch control in the menu. If the batch run is interrupted by loss of flow it
can be set to restart at the beginning of its run after a delay period that is set
in the delayed restart function. If you select single batch from the menu,
delayed restarting does not appear in the menu as an option.
REPEAT BATCH
The F29 can be set to run a pump for a set time, called a batch. The batch
run time can be from 1 minute to 99 hours 59 minutes in increments of 1
minute. To use batch control press
(^)
followed by
(P)
.
BATCH CONTROLLER
The pre-start delay timer delays the starting of the pump each time the F29
is powered up. The range of adjustment is 0 to 64,800 seconds (zero to 18
hour
s) in 1 second increments. As soon as the set time has elapsed the
pump will start and run normally. The pre-start timer can be used to allow
peripheral equipment time to boot up or to run prior to running the pump.
It can also be used to sequence or stage the starting of multiple pumps
in sequential or cascaded transfer pumping systems. Starting pumps
sequentially rather than all at once in such systems greatly reduces the
current draw on the power supply and ensures each pump spins up to full
speed before the following pump starts.
To use the pre-start delay timer, press
(^)
followed by
(P)
. Use the
(^)
or
(v)
button to enter a suitable delay period. The display increments up in 60
second steps and down in 1 second steps. Press
(P)
to lock your selection
in and move to the next screen.
PRE-START DELAY TIMER
27
