Series 3700 System Switch/Multimeter Quick Start Guide
Section 3
:
Rear Panel
Document Number: 3700S-903-01 Rev. A / August 2007
3-7
Module installation
WARNING
Slot covers must be installed on unused slots to prevent personal contact
with high voltage circuits.
Perform the following steps to install a switching module into the Series 3700 mainframe:
1. Turn the Series 3700 off and disconnect the power line cord and any other cables
connected to the rear panel.
2. Position the Series 3700 so that you are facing the rear panel.
3. Remove the slot cover plate from the desired mainframe slot. Retain the plate and screws
for future use.
4. With the top cover of the switching module facing up, align the module's card edge into the
slot's card guide and slide in the module. For the last ¼ inch or so, press in firmly to mate
the module connector to the mainframe connector.
5. On each side of the module, there is a mounting screw. Tighten these two screws to secure
the module to the mainframe. Do not overtighten.
6. Reconnect the power line cable and any other cables to the rear panel.
Содержание 3706
