![background image](http://html2.mh-extra.com/html/keithley/2001-tcscan/2001-tcscan_instruction-manual_3982931073.webp)
4-10
4.4
Calibration
There are two calibration procedures given here. The first
procedure establishes the specified accuracy of the Model
2001-TCSCAN card with a calibrated thermistor probe mon-
itoring the temperature of the isothermal block. The second
procedure establishes an ice-point reference for a piece of
thermocouple wire from the spool intended for a Model
2001-TCSCAN application.
Both calibration procedures should be performed at an ambi-
ent temperature of 23
°
C
±
3
°
C, and a relative humidity of less
than 70%.
NOTE
It is recommended that the Model 2001-
TCSCAN be calibrated in the same Model
HI
LO
Channel 2
HI
LO
Channel 3-4
Channel 5
HI
LO
Channel 6
HI
LO
Channel 7-9
Channel 10
HI
LO
OUT A
OUT B
HI
LO
2-Pole
4-Pole
Model 2001-TCSCAN
Model 2001
Chassis Ground
REF
JCN
Channel 1
HI
Model 6517
Input
(Red)
Banana Cable
Common
V-Source
HI
LO
Ground
Link
Removed
Model 237-ALG Triax Cable
Banana Cable (one
end unterminated)
Figure 4-6
Connections for HI and LO terminal to chassis ground isolation tests
2001 Multimeter being used for normal
applications.
4.4.1
Calibration with thermistor probe
This procedure requires a calibrated thermistor probe (Ther-
mometrics Series CSP A207A or equivalent). The test can be
automated with a bus controller.
Bench reset conditions are assumed for the Model 2001. In
general, the procedure has the followings steps:
1. Set the Model 2001 Multimeter to the 200k
Ω
range.
(The short circuit current is 7
µ
A. Due to the self-heating
effects of the thermistor probe at higher current, do not
Содержание 2001-TCSCAN
Страница 1: ...Contains Operating and Servicing Information Model 2001 TCSCAN Scanner Card Instruction Manual...
Страница 63: ...Operation 3 34...
Страница 83: ......
Страница 84: ......