Keith Running Floor II Metric, Руководство по установке, Страница: 43 / 49

d. Weld on wear strips or filler strips. Shield the floor seal from weld splatter.
Use a heat sink to prevent damage to the floor seal.
e. Apply a 3mm diameter bead of SikaFlex 221 adhesive sealer into the
exposed seal groove. The bead should be from the end of the seal to the end
of the slat/plank. Hold the caulking gun at a 60° angle to the floor slat/plank.
Push the bead, do not pull (Figure 48).
f. Pull the seal flush with the end of the slat/plank. Apply adhesive to the anchor
screw. Install the anchor screw (Figure 49). Do not tighten the anchor screw
too tightly. Allow the adhesive to dry before installing the slat/plank.
Figure 48
Figure 49