Keith Running Floor II Metric, Руководство по установке, Страница: 42 / 49

7.6 Trimming a floor slat/plank (After seal is installed)
a. Cut the floor slat/plank to the required length. Do not damage the floor seal.
The rear wear strips and front filler strips must be replaced if removed by
shortening the floor slat/plank. If there are wear strips or filler strips installed
on the slat/plank, it is recommended to cut off the opposite end.
b. Slide the loose end of the floor seal away from the end of the slat/plank as far
as possible (Figure 46).
c. Inspect the ends of the floor slat/plank. De-burr the seal groove. Chamfer the
outside edge of the floor slat/plank opposite the seal groove (Figure 47).
Figure 46
Figure 47
.38mm