Keith Running Floor II Metric, Руководство по установке, Страница: 25 / 49

5 FLOORING
After paint dries, the flooring can be installed. The slats/planks slide on plastic
bearings. Hold-down bearings mounted at the rear end keep the slats/planks down.
The aluminum floor slats/planks are bolted to shoes on the cross drives.
5.1 Slide bearings
1. Compare bearing dimensions with cross-member flange width.
The gap in the bearing should exceed the flange width of the cross-member.
The standard bearing gap is 62mm. Milling can enlarge the gap to 100mm.
1 SUB-DECK
I-12 2 SLIDE BEARING
3 HOLD-DOWN BEARING
2. Snap bearings on the square tube at the junction of each cross-member.
No tools are needed. (Figure 28).
IMPORTANT: Do not put a bearing on the front cross-member of the trailer if the floor
slat/plank will slide beyond the center of this bearing in the backward position.
Figure 28