![background image](http://html1.mh-extra.com/html/keiser/m3/m3_user-and-service-manual_3924237022.webp)
WARNING:
Perform the operation below before riding to make sure the bike is fully operational. Failing to test a bike prior
to normal use will void your warranty and could result in serious injury.
CHECKING FOR PROPER OPERATION
Pre-Ride Checklist
Please inspect bike carefully and thoroughly before riding.
All Parts Correctly Installed
Acorn Nuts Torqued At 45 Nm (35 ft-lbs)
Pedals Loctited and Torqued To 45 Nm (35 ft-lbs)
All Screws and Nuts Properly Torqued and Tightened
Handlebar and Seat Adjustments Operate Properly
Bike Has Been Polished With Paste or Spray Wax and a Clean Cloth
Computer Installed and Calibrated and In Working Order (See “Calibrating The Computer”)
Test Ride
Your bike should now be ready to test ride.
Adjust the seat and handlebar for proper height and comfort.
Secure your feet in the pedals.
Move the shifter toward yourself and down and begin pedaling.
The computer should wake up and display “ODO” and total distance ridden across the bottom. After approximately 10
secs “ODO” will change to gear and trip.
Now move the shifter up and note the gear changing on the computer and the resistance getting harder.
Ride at various speeds and resistances to check for noise and vibration.
Move the shifter to full forward position to check that the emergency brake stops the flywheel from turning.
You have completed the test.
Enjoy your ride.
NOTE:
Since we are always striving to improve our products; our products are subject to change without notice.
NOTICE
Users, agents or anyone directing the use of this equipment shall determine the suitability of the product for its intended
use, and said parties are specifically put on notice that they shall assume all risk and liability in connection herewith.
1.
2.
3.
4.
5.
6.
7.
8.
9.
20
Содержание M3
