09
INSTALLATION INSTRUCTIONS
TRIPLE TRAINER
3/8- 16x3/4 in.
Screw with Washer
(Qty 4)
Lift here
HEAVY EQUIPMENT
HELP REQUIRED
CRUSH HAZARD
KEEP FEET CLEAR
TRIPLE TRAINER UNIT INSTALLATION
•
With your helper, carefully
place one of the Functional
Trainer units onto the Floor Mount Plate, align mount
holes as shown.
•
Start Screw with Washer into a threaded hole (qty 4).
•
Fasten Screws using a 9/16 inch Socket and Ratchet.
•
Torque Screws to 25–30 ft-lbs (34–41 Nm) using a Torque
Wrench and 9/16 inch Socket.
•
Repeat steps above for the remaining two units.
STEP-BY-STEP INSTALLATION GUIDE
INSTALL FLOOR MOUNT PLATE (QUANTITY 3 CONCRETE SCREWS)
•
Recommended: Apply adhesive directly onto Screw Anchor leading threads.
•
Insert the Screw Anchor through the Floor Mount Plate and into the drill holes.
•
Tighten the Screw Anchors into the concrete until the hex-washer head contacts the surface of the Floor Mount Plate.
•
Immediately remove any adhesive spill using a clean cloth.
CONCRETE WITH FLOORING OVER 5/8” (16 mm)
•
Use 3/8” dia. anchor with appropriate length (not supplied) and Spacers (supplied).
•
Anchor minimum embedment required: 3” (76 mm).
•
Follow anchor manufacturer’s instructions for tightening the anchor, including torque specifications.
4
CONCRETE WITH FLOORING
CONCRETE
Spacers
Floor Mount Plate
Floor Mount Plate
Screw Anchor
Screw Anchor
Flooring
Concrete
Concrete
{
5
6
FINAL INSTALLATION / SETUP
•
For pre-assembled Triple Trainer, continue to
“AIR SYSTEM SETUP & FINAL INSTALLATION”
page 11, Step 9.
•
For a Triple Trainer unit that requires assembly,
continue to Step 6.
B
A
Continue to
“AIR SYSTEM
SETUP & FINAL
INSTALLATION”
page 11, Step 9
Continue to
Step 6
B
A
