Keimling Naturkost FreshLife FL 3000, Руководство по эксплуатации

Страница: 36 / 60

FreshLife
®
Automatic Sprouter 36
Troubleshooting
Problem Possible Reason Solution
The sprinkler (2)
does not turn
Residue in the water tube (4)
obstructs the flow of water
resulting in water pressure
that is insufficient to turn the
sprinkler (2)
First, you should test your sprouter with
the water barrel (7) and the water pressure
control tube (6) There should be a strong
stream of water coming out of the tube
Then you attach your sprout barrel (5)
onto the water barrel and insert the
corresponding water tube parts (4) into the
middle of the sprout barrel Switch on the
appliance and check the water stream again
(without the sprinkler (2) If it works well,
you can put the sprinkler onto the end of
the water tube If, contrary to expectations,
the sprinkler does not turn, it is probably
clogged Replace it with the replacement
sprinkler included in delivery or remove
any impurities in the clogged sprinkler (see
pg 11, Point 6)
The sprouts are cultivated in the
double-layer FreshLife
®
This
means that the water must travel
twice as far, which influences the
water pressure
Check that the water tubes (4) are
correctly assembled, and use a sharp
object to clear up any clogs in the
sprinkler (2) (see pg 11)
The water cannot evenly flow
out of all holes The sprinkler (2)
is damaged, and it sprays the
water unevenly
Replace the damaged sprinkler (2)
Also clean the water tubes (4) (see
pg 11) and select the optimal water
pressure (by adjusting the turning device
on the water pressure control tube (6),
see pg 8)
If your sprinkler (2) still does not turn even after you have thoroughly
cleaned it and optimally adjusted it, as long as the water still sprinkles, it is
absolutely sufficient for a successful sprout cultivation since the water gets
to where it is needed – the roots