3.8
Assembly
3.8
Fitting the Back Supports
1. Tighten the two sets of nuts and bolts fixing the Squaring arm two the Main Column of
the machine.
2. Tighten the two screws to clamp the Squaring Arm to the two Legs.
3. Separate the Supports into left hand and right hand.
NOTE:
The screws fit into special grooves in the underside of the Supports. The
grooves have teeth on their sides to match the teeth of the screw thread, the screw can
be fitted in the groove anywhere along its length but be careful to make sure the screw is
kept perpendicular to the Support and not screwed in out of line.
4. Place one of the 16 Long Screws in each of the holes along the legs of the machine,
fix each Support in turn ensuring the ends of the Supports are firmly against the Main
Column and the screws are aligned with the special grooves as explained above.
5. Fix the end of each Support in position with the Brackets and short screws as shown.
1 1
2
2
3
4 5
