Kedacom IPC121-Ei7N Series, Руководство пользователя

Страница: 25 / 39

HD IP Camera User Manual
19
Picture 4-11 Motion Detection
4.4.1 Set Area
Motion detection supports full area detection and maximum 4 user-defined areas.
4.4.2 Clear Area
Start from an undefined square and draw an area that contains the defined area, or
click the defined squares one by one to clear setting, or click
“Clear” to clear setting.
Save to make settings effective.
4.4.3 Disable Function
To disable this function, uncheck the checkbox Enable.
4.5 Alarm Linkage
Alarm Linkage is the system reaction after an alarm signal is received. It is to raise watch
man’s attention to handle the event.
1) Go to Settings>Event>Video Analysis>Motion Detection , check
“Enable”.
2) Click
“Edit” and the image will be divided into 16 columns and 12 rows of squares.
Click a square and drag an area from it, then the area will turn purple and is the
motion detection area. A camera can support maximum 4 areas.
3) Drag the slide bar to adjust Sensitivity.
4) Click
“Edit”. On the popup page, check durations and set start time and end time.
5) Click
“Copy” to copy the defined motion detection time to a certain day or the whole
week.
6) Select
“Linkage Type”. It is the alarm output method when an alarm is detected in
the defined area.