P30
UDP commands
UDP Programmers Guide V2.01
31
© KEBA
Reply structure
Field
Contents
Additional Description
-
TCH-OK: done
Generic confirmation message
3.3
UDP commands with permanent effects
The following UPD commands should not be used regularly, especially not
with mobile applications, as they change the device`s behavior permanently
until they are overwritten or the device gets rebooted.
3.3.1
UDP command: ena
The
ena
command can be used to permanently disable the system by using
the parameter 0. After receiving
ena 0
the device will be disabled until it is
rebooted or
ena 1
or
currtime
are used. The execution of
ena 0
will take
approximately 1 second. If
ena 0
is used, then no other command should be
sent for 2 seconds to ensure an undisturbed execution of the disable com-
mand.
Command structure
Command
Parameters
Additional Description
ena [m]
[m]: modifier
Modifier for the
ena
command
Possible values: 0, 1; Other values may not
be used.
Reply structure
Field
Contents
Additional Description
-
TCH-OK: done
Generic confirmation message
Example
●
Authorization is set to "OFF"
●
UDP command
ena 0
was sent before the vehicle was connected to the charging sta-
tion.
●
Charging station and vehicle are ready to start the charging session.
