|
keatingofchicago.com
8
Replacement:
1. Install removed plumbing parts into replacement
pump and motor suction port in same orientation
noted at removal using tefl on tape or a good food
grade pipe joint compound on male threads only of
disassembled plumbing parts.
2. Position pump and motor onto its base and secure
loosely with removed screws, fl at washers and nuts.
3. Connect tagged electrical leads to motor terminals.
Install motor junction box cover.
4. Tighten suction tube coupling nut onto mating
pump suction port fi tting. Then fully tighten pump and
motor mounting hardware.
5. Position front panel onto frame and secure in posi-
tion. Install bottom cover.
6. Position fi lter right-side-up and clean up oil absorb-
ing rags.
7. Connect hand hose assembly to quick disconnect
on discharge port.
F. HEAT TAPE
Removal:
1. Disconnect fi lter from electrical power source.
NOTE:
Remove all oil from fi lter vessel. Filter must be
positioned on its end to access heat tape.
2. Raise front (power cord) end of fi lter and rest fi lter
on oil absorbing rags on its back end.
3. Remove bottom cover attaching screws; remove
bottom cover.
4. Sketch course defective heat tape follows to as-
sure oil and various components can be suffi ciently
heated during fi lter operation preventing any solidifi ca-
tion. Then remove heat resistant mastic tape holding
heat tape to fi lter components.
5. Remove hardware securing heat tape ends to elec-
trical terminals. Unwind heat tape from fi lter
components.
Replacement:
1. Wind replacement heat tape onto and around fi lter
components following same course of removed
defective heat tape.
2. Secure heat tape ends to electrical terminals with
removed hardware.
3. Use a heat resistant mastic tape to secure heat
tape in place on fi lter components.
4. Secure bottom cover with removed attaching
screws.
5. Position fi lter right-side-up and clean up oil absorb-
ing rags. (See Cleaning Instructions)
