23
4.1.2 Gyro Expert Setting
1
)
Sensor gain
The parameter controls the gain
of
signal
amplifier
.
You may not modify it in most case.
2
)
Tail delay
The parameter
is used to fit
feature
of
tail
servo
.
The
response
speed
of tail servo is
slower
,
the
parameter
should
be
set larger
.
If
some
high
quality
servos
are used, you
should set a little value, such as 0.
3
)
Head holding angle range
The parameter controls the inertia of turning. The inertia means the extra rotation when you
make a direction turning.
When you begin moving the rudder stick, it will cause a rotation (head direction changing of
the helicopter), when you stop moving the rudder stick, the helicopter will not stop rotation
immediately because of the inertia, it
will
rotate
an
extra
angle
before
stopping
.
The
parameter
controls
the
angle
.
4.2 Adjusting
'
Advanced
parameters
'
The page controls working mode of Flymentor 3D
.
It
is
strongly recommended to
keep them as
factory setting when you do not know them well.
KDS Flymentor 3D
User
Manual
07-17-平衡仪说明书(英文).pdf 26
2009-8-3 15:06:48